Пока нашел такую картинку:
И описание:
Lay down the fog light wiring (7) on the vehicle as shown in the figure, by following the instructions below. Disconnect GPS preset blanking cap from main wiring and connect it to fog light wiring connector (7A).
Connect fog light wiring (7) to main wiring GPS and fog spotlight connector (N). Tie left spotlight branch to main wiring as shown in the figure (Y) and connect it to left spotlight wiring connector (1A). Tie spotlight switch (8) wiring (8E) to the other cables as shown in the figure (X). Tie spotlight switch branch to main wiring as shown in the figure (Y) and connect it to spotlight switch wiring connector (8F). Tie right spotlight branch to main wiring RH side branch as shown in the figure (V). Tie right spotlight branch to frame as shown in the figure (W) and connect it to right spotlight wiring connector (1B).
Check spotlight correct operation. If spotlights do not work, check all the electrical connections you have just made, making sure they have been made to the highest professional standards.
Refer to the workshop manual and refit all the removed parts as follows: Refit fuel tank (E) as specified in “Refitting the Fuel Tank”. Refit tank fairings (D) as specified in “Refitting the Tank Fairings”. Refit front half fairing (C) as specified in “Refitting the Front Half Fairing”.
Refit left and right panels (B) as specified in "Refitting the Left Panel” and “Refitting the Right Panel”. Refit seats (A) as specified in “Refitting the Seat”.